Custom Silicone Mold Manufacturer

The advantages of custom silicone mold manufacturer are numerous. These products are ideal for prototyping. They can be used to determine fitment and functionality, or simply to check the feasibility of the product on the market. A prototype is much easier to change once it is produced, rather than a tool that has to be cast. The following are some common reasons why a silicone powder glass mold is useful for prototyping.

A prototype can be a good choice for a one-off project. You can create a duplicate of a piece and have it reproduced again. You can use a Lego brick frame, or a glued-on plate. You must be sure that the frame is a tight fit, as the silicone will spread and make it difficult to work with. The mold can be polished to give a glossier finish.

Once the prototype is complete, the next step is to build the base plate. Glass is not a suitable base material, so you can use a smooth MDF board or a planed wood. You should make sure that the side walls protrude at a distance of about ten millimetres. After that, pour the silicone over the prepared blank and let it dry. The silicone should be cured between 18deg C and 22deg C, but a lower temperature will prolong the drying process.

Advantages of a Custom Silicone Mold Manufacturer

Once the mold is prepared, it must have a base plate with a smooth surface. Glass is not a suitable base plate because of its fragile nature. A wooden frame with a smooth MDF board is a better choice. Its sides and bottom should be a minimum of 10 millimetres high, so you can attach them with a drop of hot glue. Then, you can mix the silicone mass by pouring it on the frame. When you are ready to start the molding process, you should leave enough time for the silicone to cure.

The process to make a silicone mould is quite simple. However, it is important to consider the number of different factors when using this material. It is important to make sure that you choose the right material for your project. If you are using a silicone mold for a large-scale production, make sure that it is not overstretched. The materials must be flexible and easy to mold. A mould should be free of defects.

The silicone mold is a great material for prototyping. It is easy to use and produces top quality results. The silicone mold is a liquid and should be mixed 1:1. Once mixed, it is a liquid with a low viscosity. It is important to follow the manufacturer’s instructions. Afterwards, the mold should be set at room temperature to ensure a long-lasting silicone glass pendant.